12V Low Flow
NOTE: This item can not be installed without the Installation/Extraction Tool or Silicone Sleeves. The protective caps are required to create a good seal.
Material: Stainless Steel Upper Barb: 1/4" ID Tubing Lower Thread: For Extensions
The Vapor Pin ® was specifically designed to collect soil gas for sub-slab vapor-intrusion assessments. By sampling the soil gas directly beneath the building's floor, the Vapor Pin System provides the most accurate risk assessment of vapor intrusion. Sub-slab gas most closely represents indoor air contamination without indoor or outdoor air quality factors. The convenience of the close-to-surface location makes sampling from these sites easier to collect using hand-held equipment. The Vapor Pin's compact design makes it possible for a single technician to install and sample. Vapor Pins ® are installed by drilling 5/8-inch holes through the floor with a hammer drill. For Flush mount solutions, the Vapor Pin Secure Cover can be installed with a 1-12" hammer drill.
After installing the Vapor Pin and allowing soil gas to equilibrate for two hours or more, connect the Summa canister, Tedlar bag, or another sample container to the Vapor Pin ®, purge the dead space in the sample train, and collect the sample.