2" Internal PVC Pipe Cutter SCH80

Make accurate, square cuts at floor level or in other blind locations with this internal plastic pipe cutter. With it's unique design and spring-loaded blade design, this cutter makes cuts to your specified depth in seconds. Specifications: Pipe Size: 2" Sch 80 Pipe Material: PVC, ABS, or DWV Min Cut Depth: 1.625" Max Cut Depth: 8.25" Power Source: 1/2" capacity, 350–450 RPM drill, rated at 4.6 to 6 amps
Directions for Use: 1. Measure desired “X” depth. 2. Set “X” cutting depth and tighten set screw securely to avoid any change in the “X” depth while cutting.
3a. Tip at a shallow angle so that the blade is inside of the pipe. 3b. Push to depress blade until blade drum will enter the pipe.
4a. Chuck shaft in HD 1/2” drill motor, 1/2” capacity, 350-450rpm, 4.5-6 amps. Keep flange in contact with the end of the pipe and turn on drill motor. Be sure rotation is clock wise (normal forward). The blade will self feed until the cutoff is complete. NOTE: Hold trigger grip and side handle securely to control torque reaction. 4b. The cutoff portion will remain on the tool. 4c. Depress the blade, flush with cutter drum and pull tool out of cutoff portion of pipe.
CAUTION: Do Not attempt to cutoff below floor level without a 1/2” thick, soft stub wrapper or equal clearance around the outside of the pipe. The blade will be severely damaged if it contacts the concrete slabs or other hard floor materials.

Search